Connect-It Interface Card Installation
Make sure you have these items:
-
Connect-It module
-
Epson printer
-
small screwdriver
1) Removing the interface board from the printer
If there is a module installed in the printer you
must first remove it. Remove the two screws that securing the interface board;
then pull the board to remove it. You will reuse the screws when installing the
new module
Tip: If storing the module put
the removed interface board into an anti-static bag for storage to prevent
damage from static electricity.
2) Installing the interface
board enclosed in the package
Hold the Connect-It module as
shown in the illustration below. Push the Connect-It module
in gently until you feel
the connector fit into place
3) Secure the Connect-It module
with the two screws. Do not over tighten.
4)
4)
Change the printer settings to
match the new interface.
Dip switch settings for interfaces
Interface cards:
|
